In this study, biochar prepared from walnut shells (W-BC) demonstrated superior performance in removing metolachlor (MET) from aqueous solutions compared to biochars derived from cow dung (D-BC) and corn cobs (C-BC). The removal efficiency reached 87.89% with W-BC, significantly higher than 52.91% for D-BC and only 10.91% for C-BC. Adsorption kinetics analysis revealed that W-BC achieved equilibrium within just 30 minutes, indicating rapid adsorption kinetics, while D-BC and C-BC required up to six hours. The pseudo-second-order kinetic model best described the adsorption process, with high correlation coefficients (R² > 0.99), suggesting that chemisorption played a dominant role. The saturated adsorption capacity calculated via the Langmuir isotherm model was 96.15 mg g⁻¹ for W-BC, far exceeding 37.88 mg g⁻¹ for D-BC and 11.98 mg g⁻¹ for C-BC. This high capacity is attributed to W-BC’s large specific surface area (358.67 m² g⁻¹), high total pore volume (0.22 cm³ g⁻¹), and small average pore diameter (1.9 nm), which facilitate extensive pore-filling and molecular interactions.Protein A Agarose Purity & Documentation
The influence of environmental factors on MET adsorption was systematically evaluated. The optimal removal efficiency occurred at low pH (pH 3.0), where protonation of electron-withdrawing groups enhanced π-electron donor-acceptor interactions between W-BC and MET. As pH increased, hydrolysis of surface functional groups reduced hydrogen bonding capacity, leading to decreased adsorption. Ionic strength had a complex effect: increasing Na⁺ concentration initially improved MET removal due to salting-out effects and reduced electrostatic repulsion, peaking at 0.05 mol L⁻¹; however, further increases caused a decline, likely due to competitive ion effects and pore blockage. Adsorbent dosage showed a positive correlation with removal rate, reaching saturation beyond 0.20 g L⁻¹. Regeneration tests indicated that W-BC retained over 50% of its original capacity after two cycles, demonstrating good reusability despite some decline due to pore fouling.
Weight analysis based on Pearson correlation revealed that BC type contributed most significantly (46.11%) to MET adsorption, followed by initial MET concentration (19.29%). Physical properties such as BET surface area, pore volume, and pore diameter also exhibited strong correlations (7.77–7.81%), confirming their critical role. Elemental composition analysis indicated that W-BC had the lowest H/C ratio (0.Tafasitamab web 295) and moderate (N+O)/C ratio, reflecting high aromaticity and polarity—favorable traits for adsorbing organic pollutants like MET.PMID:35015083 FTIR and XRD analyses confirmed the presence of abundant oxygen-containing functional groups (e.g., –OH, –COOH) and graphene-like structures formed during pyrolysis at 700 °C. These features promote both physical adsorption through microporous filling and chemical interactions via hydrogen bonding and π–π electron donor-acceptor mechanisms.
Overall, walnut shell-derived biochar exhibits exceptional potential as an efficient, sustainable, and cost-effective adsorbent for metolachlor removal from contaminated water. Its high surface area, favorable pore structure, and rich functional group chemistry enable rapid and strong adsorption. These findings support further development of biomass-based biochars for practical water treatment applications, particularly in agricultural regions where metolachlor contamination is prevalent.MedChemExpress (MCE) offers a wide range of high-quality research chemicals and biochemicals (novel life-science reagents, reference compounds and natural compounds) for scientific use. We have professionally experienced and friendly staff to meet your needs. We are a competent and trustworthy partner for your research and scientific projects.Related websites: https://www.medchemexpress.com